NL Cypress-CS110926
Page 1 of 2
George Marshall - RE: Saintsbury Traffic Signal Pole Specification
From: <brad.moss@kimley-horn.com>
To: <gmarshall@coppelltx.gov>
Date: 9/26/2011 3:59 PM
Subject: RE: Saintsbury Traffic Signal Pole Specification
Thanks George. Any luck with the stamped concrete and the 12’ vs. 8’ crosswalk answer? Or the cutting thru
the existing median?
Thanks.
®
Bradley Moss, PE , LEED AP
(TX, OK, NC)
12700 Park Central Drive
Dallas, Texas 75251
Ph: 972-770-1300 Fax: 972-239-3820
brad.moss@kimley-horn.com
From: George Marshall [mailto:gmarshall@coppelltx.gov]
Sent: Monday, September 26, 2011 1:54 PM
To: Moss, Brad
Subject: Saintsbury Traffic Signal Pole Specification
Brad,
Please see below for the changes in the color of the pole:
7.0 FINISH
Painted Finish - All surfaces at the time of paint application shall be in accordance with the requirements of
Brush-Off-Blast-Cleaning as specified in Steel Structures Painting Council Specification SSPC-SP7. When
shipped, the outside of each assembly shall be coated in a manner that will assure all surfaces, at the time of
erection, will be coated with a dry, smooth, continuous, uniform, tightly adhering, nonchalking film that is a
minimum of two (2) mils thick measured over the peaks of the anchor pattern. The dried film shall contain, on a
weight basis, a minimum of 20% binder solids and a minimum of 25% pigment capable of chemically inhibiting
corrosion. A minimum of 12% of the film shall be a chromate type corrosion inhibiting pigment. The inside of
each assembly may either be coated in the same manner as the outside or may coated by an acceptable red lead
file://C:\Documents and Settings\radloo\Local Settings\Temp\XPgrpwise\4E80A164City_...1/26/2012
Page 2 of 2
primer. After erection of the assembly, the shop coat shall be touched up with shop primer. After the touch up
coat is thoroughly dry, each pole assembly shall be provided with a one (1) mil (dry) thick film of paint specified
and approved by the Engineer:
Color Product name and #: Super OGF Black; S-400
Cure: 400F- 10-12 MIN PMT
Control #: S-400
Resin Type: Super polyester resin
Gloss Level: 70-80%
“or equivalent”.
Thank You, George
George Marshall, PE
City of Coppell
Engineering
972-304-3562
file://C:\Documents and Settings\radloo\Local Settings\Temp\XPgrpwise\4E80A164City_...1/26/2012