Creekview II L2-CS 930429 6. The church should pursue the acquisition of right-of-way from the property to the
west so that they can access Samuel Blvd., thereby gaining access to the
signalized intersection at Samuel and MacArthur Blvd. for north bound vehicles.
The current drive configurations do not align with the existing median at the
southern property line, therefore traffic headed north bound on MacArthur will
need to make a U-turn at the intersection of Lake Forest and MacArthur Blvd.
7. There has been some discussion about if a deceleration lane is needed. As has
previously been stated, a traffic study should be performed to determine if the
deceleration lane will be required.
4. Round Oak Estates F'mal Plat - located along the west side of Harris Road, 120 feet
north of Dakota Lane.
The Engineering Department offered no comments concerning this final plat. Any
comments concerning this will be addressed during the review of the construction plans.
5. Creekview Phase H located at the northeast and southeast comer of Bethel School
Road and Denton Tap Road.
This was initially reviewed on April 29th and the following comments were offered:
1. Minimum finished floors should be shown on all lots.
2. A tree survey should be provided as requested by the Planning and Zoning
Commission.
3. The access easement through Lot 3, intersecting Denton Tap at the southern
boundary line of Lot 3 and the access easement to the property to the south
should be shown on the plat.
A revised plat was provided at the May 6th meeting. The revised plat showed the
minimum f'mish floors and the access easement along the southern property line of Lot
3. However, it did not show the 24 foot access easement to the property to the south,
therefore the Engineering Department offers the following comments:
1. The 24 foot access easement to the property to the south should be shown on the
plat.
6. Gibbs Station Phase H F'mal Plat - located along the east side of MacArthur Blvd.
near Village Parkway.
April 29, 1993 Comments:
1. All easements should be shown on the plat.