ST0001-CS020718 (2)Suzan Taylor- RE: Creekview Drive e Page
From: "Schnitger, Chris" < cschnitger @sradesign.com>
To: 'Suzan Taylor' < staylor @ci.coppell.tx.us>
Date: Thu, Jul 18, 2002 2:31 PM
Subject: RE: Creekview Drive
I'll see what I can do. Billy has a lot of cleanup work to do before he
starts laying down sod.
Chris Schnitger, P.E.
Schrickel, Rollins & Assoc.
1161 Corporate Dr. W.; Ste. 200
Arlington, Texas 76006
(817) 649 -3216
(817 649 -7645 FAX
- - - -- Original Message--- -
From: Suzan Taylor [mailto :staylor @ci.coppell.tx.us]
Sent: Thursday, July 18, 2002 2:25 PM
To: cschnitger @sradesign.com
Subject: RE: Creekview Drive
Larry and Billy are looking at next week to start the installation of
the solid sod and the hydromulching.
>>> "Schnitger, Chris" < cschnitger @sradesign.com> 07/18/02 11:13AM >>>
Actually I think Billy said that the conduit is buried 24" in the
parkways
and I guess they buried it 36" at the drive location. I'm assuming
that was
done per TXU /Oncor's requirements. It was the electricians
responsibility
to install the conduit per TXU /Oncor's requirements. I think Larry was
the
one that brought it to Billy's attention. I went ahead and asked Billy
to
see how much it would cost to lower the conduit. If it ends up being
too
much money then we will adjust it with the Tennis Center project.
I really think we need to look at the sod /hydromulch issue as we get
closer
to installing it. I think we agreed that we want to solid sod the
disturbed
areas on the berms. I'll look at the plans again.
Chris Schnitger, P.E.
Schrickel, Rollins & Assoc.
1161 Corporate Dr. W.; Ste. 200
Arlington, Texas 76006
(817) 649 -3216
(817 649 -7645 FAX
- - - -- Original Message---- -
From: Suzan Taylor [ mailto :staylor @ci.coppell.tx.us]
Sent: Thursday, July 18, 2002 10:29 AM
Suzan Ta Y lor - RE: Creekview Drive _ Pa e 2
To: cschnitger @sradesign.com
Subject: Re: Creekview Drive
On March 6, 2002, you sent me an e-mail concerning the depth of the
conduit. All conduit was to be installed at 18" below subgrade to
ensure there was enough clearance for any future drive approaches.
Maybe this was only done at the original Tennis Center drive location.
I will need a drawing of the solid sod/ hydromulch locations since the
locations are going to differ from the locations as stated in the
specifications.
>>> "Schnitger, Chris" <cschnitger @sradesign.com> 07/18/02 10:23AM >>>
Suzan,
Billy called me this morning with a couple of questions and I wanted
to
pass
them on to you so you know what is going on. The first question
regarded
the conduit for the street lighting. We had a drive location shown on
the
original construction documents for the Tennis Center but it has since
been
moved. The new sidewalk plans reflect the location which is
approximately
200 feet further to the east. ISI lowered the conduit in the location
of
drive on the original plans but the conduit that is located at the new
drive
location is at normal depth. I think it would be best if we had them
lower
the conduit at the new drive location, right now. Of course Billy is
talking about an added cost. We have a cost for the conduit and I
don't
know that we would need new conduit. We just need the conduit
lowered.
If
it ends up costing too much then we might be able to do it cheaper
with
the
Tennis Center. I'm going to ask ISI to get us a price to lower the
conduit.
We're only talking about 30-40 feet. Material costs alone shouldn't
be
more
than $200.
The second issue was a concern that Larry had regarding the sidewalk
and the
curb inlet on the far eastern end of the Creekview. Larry feels like
the
slope from the sidewalk to the curb inlet is too severe. The plans
show
this to be a 25% or 4:1. It's a manageable slope. We can lower the
walk or
E Suzan Taylor RE: Creekvie .
, w Drive Pale 3
pull if further from the inlet but that will increase our cut into the
bank.
In our opinion the grade isn't severe but I will double check with a
few
people in our office.
Chris
Chris Schnitger, P.E.
Schrickel, Rollins & Assoc.
1161 Corporate Dr. W.; Ste. 200
Arlington, Texas 76006
(817) 649 -3216
(817 649 -7645 FAX