ST9801-SP010416 4.15
1725-- KEL-GUARD ACRYLIC METAL PRIMER
I ~ Primer for Exterior and Interior, Ferrous Metals,
z _~ Galvanized Metal and Aluminum Surfaces
O~ PRODUCT DESCRIPTION Followthe Steel Structures Painting Council's Specifications
An off white acrylic latex, rust inhibitive primer for properly for Surface Preparation depending on the requirements of
~ ~ prepared, clean metal surfaces. Provides outstanding the specific project: SSPC- SP1 Solvent Cleaning, SSPC-
O -- adhesion, flash rust resistance, inhibits corrosion and may SP2 Hand Tool Cleaning, SSPC-SP3 Power Tool Cleaning,
i .- be topcoated with either latex or alkyd finish coats. SSPC-SP5 White Metal Blast, SSPC-SP6 Commercial
TYPICAL USES Blast, SSPC-SP7 Brush-Off Blast, SSPC-SP10 Near White
..j z For properly prepared ferrous metals, galvanized metal and Blast.
~ ~ aluminum surfaces: sheet metal, gutters, down spouts, SPECIFICATIONS
pipe, railings, roof vents, metal doors and frames, ornamen-
PRIMER:
tal iron and structural steel. Metal: 1725 Kal-Guard Acrylic Metal
LIMITATIONS (Not to be construed as all-inclusive) Primer
For optimum pedormance on bare ferrous metal, two coats
of primer are recommended. FINISH COATS: See Kelly-Moore Systems Chart
"Metal Surfaces".
PRODUCT CHARACTERISTICS PRODUCT HANDLING
SPREADING RATE: 250-350 sq. ft. per gallon, depending APPLICATION: Brush, roller or spray.
on method of application, porosity and texture of surface.
TEMPERATURE: Do not apply when material, air, and/or
DRY FILM THICKNESS: 1.6 mils per coat.
surface temperature is below 50° F. or if rain is imminent
within six hours. PROTECT FROM FREEZING.
SOLIDS: Approximately 35% by volume.
THINNING: Apply at can consistency. If thinning is neces-
DRYING TIME (at 75° F. and 50% R.H.): To touch: I
sary to maintain workability, do not exceed one-half pint of
hour; to recoat: overnight, water per gallon. Excessive thinning will reduce product
FINISH: Flat. performance.
COLOR RANGE: Off white. CLEAN-UP: Promptly, with warm, soapy water.
SIZES: Five gallon pails, one gallon cans, and quarts. VOC: Maximum 340 GPL.
SURFACE pREpARATION
g
GENERAL: All surfaces must be firm, dry and cleaned free
of dust, dirt, oil, grease, wax, chalky or loose paint, rust, ~ O
loose mill scale, weld splatters, and soluble salts from ~ Ill
welding flux or any other contamination that would ad-
versely affect the performance of the coating.
Umited Warranty
The statements made on this bulletin, product label, Or by any of our agents concerning this material are given for information only.
They are believed to be true and accurate and are intended to provide a guide to approved construction practices and materials.
As workmanship, weather, construction equipment, quality of other materials and other variables affecting results are all beyond
~ our control, Kelly-Moore Paint Company, Inc., does not make nor does it authorize any agent or representative to make any
warranty of MERCHANTABILITY OR FITNESS for any purpose or any other warranty, guarantee or representation, express or
implied, concerning this material except that it conforms to Kelly-Moore's quality control standards. Any liability whatsoever of
Kelly-Moore Paint Company, Inc. to the buyer or user of this product is limited to the purchaser's cost of the product itself.
KELLY-MOORE PAINT CO., INC. / 987 COMMERCIAL ST., SAN CARLOS, CALIF. 94070 1.94