Loading...
DFW Trade 1P/PP-CS 950511 (2) sections of this Article 5. 2. Base flood (including design base flood) elevation data shall be generated for subdi,~4sion proposals and other proposed development including manufactured home parks and subdivisions if not other~4se provided. 3. All subdivision proposals including manufactured home parks and subdivisions shall have adequate drainage provided to reduce exposure to flood hazards. 4. All subdivision proposals must have the following note placed on the preliminary and final plat: "Floodplain Development Permit Application No. has been ~/~_~E; filed with the City of Coppell Floodplain Administrator on ~l(4~13d~TJP~-(/ , Floodplain Administrator, 5. All subdivision proposals shall have the boundaries of the 100-year floodplain and floodway clearly shown on the preliminary and final plat. 6. All lots within or adjacent to the 100-year floodplain shall have the lowest floor elevation for each building site shown on the final plat. 7. When any part of a subdivision lies within or adjacent to the 100-year floodplain; a permanent bench mark tied to a designated National Geodetic Vertical Da~rn marker shall be established within the subdivision at an accessible location. The bench mark and tie shall be located and referenced with ail pertinent information on the final plat along with a registered public ~ surveyor's seal. 8. When any part of a completed subdivision is within or adjacent to the 100- year floodplain, the following note must be placed on the final plat: Whe developer, builder, seller, or agent shall inform in writing, each prospective buyer of subdivision lots or property located within special flood hazard areas of this site that such property is in an identified flood hazard area and that all development must conform to the provisions of the City of Coppell Floodplain Management Ordinance." The written notice shall be filed for record in the county Deed of Records 28 SUBDIVISION REGULATIONS - CITY OF COPPELL, TEXAS SECTION XI - FILING OF PLAT SECTION XI - FILING OF PLAT A. After approval of the Final Plat by the Municipal Authority and correction of the plat as required by the Municipal Authority and the Planning and Engineering Departments, the Developer shall submit filing fees and the required number of copies for filing with the County Clerk. These copies shall bear all required signatures of City Officials. After signature by the City Officials, the Developer shall complete the filing process and return nine (9) paper copies and two (2) mylar copies of the "filed" plat to the City. Said copies shall show the volume and page of the Map and Plat Records into which the plat was recorded by the County Clerk. If the final plat has not been submitted for signatures by City Officials within six months after approval by the City Council, the plat shall be deemed null and void, resubmittal shall be required, and the current Subdivision Regulations shall apply. ~ B. Approval block: The following notice shall be placed on the face of each Preliminary Plat by the subdivider: #Preliminary Plat for Review Purposes Only" "Recommended for Approval" Chairman, Planning and Zoning Commission Date City of Coppell, Texas Mayor Date City of Coppell, Texas C. The following certificate shall be placed on the Final Plat, in a manner that will allow the filling in of the certificate by the proper party: Recommended for Approval: Chairman, Planning and Zoning Commission Date City of Coppell, Texas Approved and Accepted: Mayor Date City of Coppell, Texas Page 30